In the majority of cases, most individuals spend quite a bit of money purchasing their forklift. Thus, it is extremely essential to take proper care of it so as to protect your investment well into the long run. It is a good idea to know the procedures that are undertaken in taking care of and maintaining this machine.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is running. For instance, if there are any misses or knocks, the machinery is defective and this should raise several concerns. Furthermore listen closely for any squealing noise that come from the belts as these noises would provide you with a wealth of information.
Some of the main components needing attention during maintenance consist of the safety warning devices, gauges, horn, the overhead guard and the lights. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also essential to check the wiring.
When the above components have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery needs to be inspected in order to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and after that change the filters. The fuel filters, hydraulic filter and the transmission filter must be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
After the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. Then, inspect every other part of the machinery including the wheels. If any type of issue or fault is detected, be sure to deal with it immediately in order to make sure the equipment is working at its safest and optimum levels.