Change a Propane Tank
Propane powered forklifts are normally utilized inside warehouses. The lift truck is made with the propane tank mounted at the back of the driver. The tanks, that look much like beer kegs, have to be replaced periodically as they have a limited lifespan. Operators of forklifts should utilize caution when handling propane tanks. Compressed gases are very dangerous, especially because the gas is flammable. Use caution when replacing and removing propane tank to prevent injury.
1 If there is a need to replace the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The lift truck should be left on until the engine dies. This procedure burns the gas off inside the transfer hose that connects the tank and the engine. Prior to taking the next steps, put on the correct safety equipment, such as insulated gloves made of either neoprene or leather. It is vital for you to protect your skin from contact with the compressed gas, which is very cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When you put in a new tank, tighten the nut to reconnect the holding straps and to reconnect the hose at the valve of the tank.
3 You can check for leaks by applying soapy water to the valve and opening it slightly. Leaking gas would cause bubbles to foam around the value. If this happens, inspect the connection hose at the nut and the valve area. The connecting nut should be re-tightened if you detect any leaks around the area of the valve, and afterward perform the leak checking process all over again. Persistent leaks mean that the connecting hose and nut must be replaced. Nonetheless, if replacing the nut and hose still does not stop the leak, the tank would need to be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. After that you can start the lift truck and resume working.